Product

Tìm kiếm sản phẩm

Tên sản phẩm

Từ giá

Đến giá

TÌM KIẾM SẢN PHẨM

Outstanding product

The Spe-ed™ SFE-2 lab-scale supercritical fluid extraction

Fractionated extraction of saponins from Vietnam ginseng using supercritical CO2, ethanol

Supercritical fluid extraction of cordycepin and adenosine from Cordyceps kyushuensis and purification by high-speed counter-current chromatography

Micro Algae | Uses for Supercritical Fluids

Aerogels | Uses for Supercritical Fluids

Applied Separations

Online support

Tel: 0908866933 - secovina@vnn.vn

Supercritical Fluid Systems

Multitube Vortexer

Supercritical Extraction System

DIN Abrasion Tester

Lab Scale Freeze Dryer

Facebook

Thống kê truy cập

Đang online 0
Hôm nay 0
Hôm qua 0
Trong tuần 0
Trong tháng 0
Tổng cộng 0

GEHMAN’S TORSION TESTER

(1 đánh giá)

Mã sản phẩm : TM-2535/TM-2536

Xuất xứ : Ueshima Seisakusho

Bảo hành : 12 months

Standard: JIS K 6261, ISO 1432, ASTM D1053 , Rubber loses resiliency as temperature goes down. The frozen rubber can't keep its essential characteristics under the temperature below Glass Transition Point. In fact, the rubber applications under severe environments such as vehicle tire in frozen area and aircraft components in the stratosphere are seriously affected. It is a vital importance with the rubber applicants to test low temperature characteristics of vulcanized rubber.

Giá sản phẩm :

Detail

Model	TM-2535	TM-2536
Applicable Standard	JIS K 6261, ISO 1432
Cooling Method	Refrigerator	Dry Ice
Number of Samples	6 (simultaneous measurement)
Temp. Range	-70°C – RT(23°C±2°C)
Temp. Rising	Every 5°C (kept at each set temp. for 5 min.)
Temp. Control	PID controlled digital temperature controller, sensor PT100Ω
Heat Transfer Medium	Ethanol
Torsion Angle Setting	Rotary encoder, minimum angle display: 0.36°
Data Processing	Data (glass transition temp. Tg) display Graph (temp. – torsion angle curve, temp. – apparent torsion modulus curve) Filing (data, test conditions, PID setting) Release of torsion wire
Safety Device	leakage breaker, overheat protector
Power Supply	200VAC, 3 phases, 30A, 50/60Hz (100VAC for PC) or specified voltage	200VAC, 3 phases, 20A, 50/60Hz (100VAC for PC) or specified voltage
Dimensions (main body)	(W)520ｘ(D)780ｘ(H)1505 mm	(W)520ｘ(D)780ｘ(H)880 mm

Đánh giá sản phẩm

Bình chọn sản phẩm:

Bình luận

Sản phẩm cùng loại

Mooney Viscometer

VR-1130 Series Mooney Viscometer: ●Measurement of Mooney viscosity for unvulcanized rubber ●Measurement of scorch time for unvulcanized rubber ●Measurement of Mooney stress relaxation for unvulcanized rubber (MODEL: VR-1132), ムーニー粘度計

Flat Die Rheometer (FDR)

Flat Die Rheometer (FDR) VR 3110 JIS K6300-2, ISO 6502, ASTM D 5289 (Oscillating Sealed Flat Die Cavity Rotorless Curemeter） FDR (Flat Die Rheometer), manufactured by Ueshima Seisakusho Co., Ltd., 加硫試験機

Blow-Point Analyzer

Ueshima Blow-Point Analyzer

Cable Abrasion Tester

The Cable Abrasion Tester is for cable insulation and is of the type that fixes a test piece in contact with abrasion tape,loads it,and moves the abrasion tape at a speed of 1,500 mm/min. The tester also measures the length of abrasion tape used until the cable insulation abrasions out and the conductor wire gets into contact with the wear tape. Applicable Standard:JIS C3406 Length of Test Piece:Approx 900mm

Low Temperature Brittleness Tester

Low Temperature Brittleness Tester The brittleness tester conforms to JIS K 6261 / JIS K 7216 and determines the brittleness temperature and the 50% brittleness temperature of vulcanized rubber and plastics in a low-temperature environment. TM-2131 is the single type which comes with a set of sample holder, holding five samples, and TM2136 is the multiple type with four sets of sample holders with which four sets of five samples can be tested continuously just by turning a dial to change sample

Dynamic Mechanical Analyzer

Ueshima Dynamic Mechanical Analyzer

GAS PERMEABILITY TESTER

GAS PERMEABILITY TESTER This tester conforms to ASTM D1434 and JIS K7126, allowing to measure gas permeability of such specimen like rubber and plastic film using differential pressure method. A cell divided by the specimen is subject to different pressure on each side of the cell. Gas permeability rate is measured from the pressure gradient changing as time passes. Measurements can be done under different temperature environment using a temperature controlled bath.

RTM Friction Tester (Tire)

FR-7225 RTM Friction Tester enables to evaluate friction characteristics of tire tread compound on material testing basis, and can be tested in Dry, Wet, Ice conditions on ring shaped road surface. Test is performed by pressing specimen on constantly rotating ring shaped wheel at free rolling condition, or with slip ratio applied in 0 to +/- 95% range and measuring the friction force. Also, max. 30deg. slip angle can be applied on the specimen against it’s tangential line.

GEER’S AGING OVEN

Ueshima GEER’S AGING OVEN Most important functions like temperature uniformity, wind velocity and air ventilation rate are in accordance with JIS K 6257 and/or JIS K 7212. ○The minimized shape of the series allows use on a table. We also provide with an exclusive stand. ○It is able to place two units in tiers, minimizing the footprint.

Tensile testing machine

Ueshima TS-2632 Tensile testing machine

The Spe-ed™ SFE-2 lab-scale supercritical fluid extraction

Flat Die Rheometer (FDR)

Mooney Viscometer

Multi-Tube Vortexer

DIN Abrasion Tester

Pilot/Laboratory Freeze Dryer

Supercritical CO2

Fractionated extraction of saponins from Vietnam ginseng using supercritical CO2, ethanol

Supercritical fluid extraction of cordycepin and adenosine from Cordyceps kyushuensis and purification by high-speed counter-current chromatography

Micro Algae | Uses for Supercritical Fluids

Aerogels | Uses for Supercritical Fluids

GEHMAN’S TORSION TESTER

Mooney Viscometer

Flat Die Rheometer (FDR)

Blow-Point Analyzer

Cable Abrasion Tester

Low Temperature Brittleness Tester

Dynamic Mechanical Analyzer

GAS PERMEABILITY TESTER

RTM Friction Tester (Tire)

GEER’S AGING OVEN

Tensile testing machine